5 Axles

CHASSIS It is manufactured from high-strength steel “I” sectioned “I” sectioned welded construction with gas welding machines in accordance with the intended use and carrying capacity of the Lowbed Trailer, taking into account overloads.

DINGL: 3 x 12 tons, or 3 x 14 tons capacity with air suspension, bottom flat scissor load and height adjustable shock absorber support. Brand is optional.

DIMENSION:Length; 8500 – 10500 mm depending on customer request and intended use. Total Length; 12300 mm – 14300 mm. Width; 2550 – 3300 mm varies upon request.

PLATFORM HEIGHT:It is determined according to the transportation purpose of the Lowbet Trailer. Generally between 900 mm and 1050 mm.

RAMPS:Optionally pneumatic or hydraulic system.

PLATFORM MATERIAL: Lowbed trailer’s platform top center front part is 3/4 sheet metal, rear center part is 8 mm (bucket placement sheet) with travertine support, wheel tops are covered with 8 mm sheet metal. KTM (Rubber Base Material) is used as standard on the sides with track contact areas.

USED SHEET METAL : It is completely Ereğli Demir Çelik product and has St37 and St52 quality.

PAINT: After all surfaces are completely deburred and cleaned with chemical liquids, two coats of paint are applied on epoxy primer.

PARK STEP 2×24 tons capacity double speed mechanical leg

AIR SUSPENSION: Height adjustment system with lowering and lifting. Supported by Z truss and suspension bellows.

ACCESSORIES: 89 / 297 / EC regulation as stipulated by the side protection device, spare wheel carrier, mudguard, 30 liter plastic water tank, reflector, plastic wheel chock, other warning and warning signs

TIRES: 245/70 R 19.5 – 265/70 R 19.5 – 295/60 R 22.5 (depends on demand)

FOOT Double-speed mechanical leg with a carrying capacity of 24 tons each.

BRAKE The brake components used are in EU Standards and designed from WABC0 brand products.

AIR HARDWARE: The air required for air suspension, front axle lift, brake circuit and ABS circuit is used from the air tank. The hoses used in this installation are polyamide and resistant to air pressure.

KING-PIN 2″ SAE/DIN compliant KingPin made of high strength forged steel.